KB400 & KB460 KLIK Knkt Status LED - Colors and Functions

The KB400 KLIK Knkt Wireless HDMI Sender and KB460 Wireless USB-C Sender allow streaming of any HDMI video source to KLIK Stik, KLIK Boks PLUS, PRO and HUB. Use the Knkt to add devices such as Document Cameras, Camcorders, Blu-ray Players, and even HDMI or USB-C equipped PCs. Simply pair the Knkt to your KLIK device (one-time operation), then connect a video source using the supplied cable, connect the USB power cable and press the button on the Knkt to start streaming.

The Knkt provides feedback by means of an LED ring that surrounds the pushbutton located on the top face of the unit. The LED ring employs color and flashing or solid display to denote status. The following table shows the various states of the LED ring and their meaning.

COLOR	Behavior	Function
White	Flashing	Ready for Pairing. Start Pairing procedure.
Green	Solid	Successfully Paired to KLIK Receiver and ready to Connect.
	Flashing	Successfully Paired to KLIK Receiver but unable to Connect. Check KLIK Receiver and network status.
Yellow	Flashing	Successfully Paired to KLIK Receiver but no Video Signal at Input. Connect an active video source to KB400.
Purple	Flashing	Firmware Update in process. Do not disconnect power.
Red	Flash 1 time, delay 3 seconds, Loop	Not Paired to a KLIK Receiver. Follow the Pairing procedure.
	Flash 3 times, delay 3 seconds, Loop	Can't connect to the Wi-Fi Router or the KLIK Wi-Fi. Check Wi-Fi Router status or KLIK Receiver Wi-Fi status.
	Flash 5 times, delay 3 seconds, Loop	Wi-Fi password is incorrect. Check password and repeat Pairing procedure.

Note that while multiple KB400 Knkt HDMI Sender and/or KB460 Knkt USB-C Sender devices may be paired with one KLIK Receiver, it is not possible to pair one KB400/KB460 with multiple KLIK Receivers. To use a KB400/KB460 with another KLIK Receiver, simply run the Pairing procedure with that receiver.